British Columbia · Energy · checked September 28, 2026

Heat loss calculations in Coquitlam

The heat loss calculation is how a heat pump or furnace gets sized for your house, and the key input is the design temperature: −6.3°C for Coquitlam, from NRCan's HOT2000 climate data for Pitt Meadows.

A kitchen table with a house floor plan, a laser measure, a tape measure and a laptop showing the plan

Design temperature

−6.3°C

The cold day heating is sized for

Heating degree-days

2,851

Mild winters by Canadian standards

Standard

CSA F280-12

The national method for sizing heating and cooling

Typical cost

$150–$400 standalone

How Coquitlam is built

Coquitlam's houses by when they were built Ten house shapes, one for each tenth of Coquitlam's 35,695 houses. Before 1961: 8%, 1961–1990: 47%, 1991–2000: 18%, 2001 or later: 26%. Older houses glow hotter.
  • Before 1961 8%
  • 1961–1990 47%
  • 1991–2000 18%
  • 2001 or later 26%
Each house stands for one in ten of Coquitlam's 35,695 houses (single-detached, semi-detached, row and duplex), drawn by when it was built. The glow shows the usual pattern: older houses tend to be leakier and less insulated. Rain marks the mild, wet winters: here moisture, not deep cold, is the main winter risk. Sources: Statistics Canada 2021 Census (table 98-10-0233-01), NRCan HOT2000 climate data.

Why the design temperature matters in Coquitlam

−6.3°C is the 10th-mildest design temperature of the 70 cities we cover. The F280 calculation works out how much heat each room loses on that design day, from the house's actual walls, windows, air leakage and ceiling insulation.

With a design day that mild, a heat pump sized to the calculation can carry most or all of a typical Coquitlam house's heating load, which makes sizing it right, rather than oversizing it, the main job.

In the Vancouver area, 32% of households heat mainly with a forced-air furnace, 31% with electric baseboards, 12% with a boiler and radiators and 5% with a heat pump; natural gas is the main heating energy for 42% of households and electricity for 39% (Statistics Canada, 2023).

Coquitlam's warm summers make the cooling side count too. CSA F280 covers cooling capacity as well as heating, so ask for both numbers: a heat pump sized only for winter can be too big for summer, which leaves rooms cool but clammy.

What CSA F280-12 asks for

The National Building Code 2020 requires the heating capacity for a house to be worked out with CSA F280, and its list of referenced documents names the 2012 edition, CSA F280-12. Provincial codes can name their own edition and climate values, so ask your designer which ones the calculation uses.

Why skipping it costs money

Contractors who size by square footage routinely oversize. An oversized heat pump costs more to buy, cycles on and off, dehumidifies poorly in summer and wears faster. An undersized one leans on backup heat. The F280 report is the evidence either way, and it's worth having before you compare quotes.

What it costs

About $150–$400 as a standalone calculation (a September 2026 planning range; quotes vary). Many energy advisors bundle it with an EnerGuide evaluation, which also gives the calculation measured air-leakage data instead of an assumption.

Coastal BC Lower Mainland and Vancouver Island

What this means in Coquitlam’s climate

Mild, wet winters and summer heat waves: fix moisture first, then cooling and heat pumps.

Coastal BC has Canada's mildest winters, but heavy rain from fall to spring soaks walls and roofs, and summer heat waves are now a health risk. Heating needs are the lowest of any region we cover, so damp, drafts and overheating are the common complaints. An EnerGuide evaluation here should look for moisture problems before any air sealing or insulation, then plan a heat pump that heats and cools.

  • Plan cooling before the next heat wave. Heat waves are now a real health risk on the coast. Health authorities recommend efficient active cooling, such as a ductless heat pump, so at least one room stays cool. Ask: Ask which rooms overheat and what it would take to cool them, especially top floors and rooms with large west- or south-facing windows.
  • Plan the switch to a heat pump. Almost all winter heating here happens at temperatures where heat pumps work efficiently, and one system can replace baseboards or a gas furnace and add cooling. Ask: Ask for a heat-loss calculation, and get your electrical panel checked early; NRCan notes electrical upgrades can take up to a year.

What else homes in Coquitlam need →

Sources for this climate guide · checked October 26, 2026

NRCan-licensed service organizations serving Coquitlam

A service organization is a company that Natural Resources Canada (NRCan) licenses to deliver EnerGuide evaluations; its registered energy advisors do the home visit. Many energy advisors also do room-by-room CSA F280 calculations for an extra fee; HVAC designers do them too. Ask for the F280 report itself, not just an equipment recommendation.

Source: NRCan list of licensed service organizations, checked September 28, 2026. Call to confirm your street is covered and ask about wait times.

Heat pump programs in Coquitlam

Heat loss calculation in Coquitlam: common questions

What design temperature is used for heat pump sizing in Coquitlam?

NRCan's HOT2000 climate data gives −6.3°C for Pitt Meadows. Your designer may use the building code's design value for Coquitlam, which can differ slightly; ask which one the calculation uses.

What is CSA F280-12?

The 2012 edition of CSA F280, Determining the required capacity of residential space heating and cooling appliances. The National Building Code 2020 requires heating capacity for a house to be determined with it.

How much does a heat loss calculation cost?

About $150–$400 standalone as a planning range; often less when bundled with an EnerGuide evaluation.

Who does F280 calculations in Coquitlam?

Many of the 30 NRCan-licensed organizations serving Coquitlam offer them, as do HVAC designers. Ask for the F280 report itself.

Do rebate programs require a heat loss calculation?

Requirements vary by program and change often. Even where it isn't required, it is the best protection against an oversized or undersized system.

Heat loss calculation near Coquitlam

Get matched with a registered advisor in Coquitlam

Tell us your postal code and what you’re planning. We’ll connect you with one licensed service organization serving your area. No spam, no shared lead lists.