Ontario · Energy · checked September 28, 2026

Thermal imaging (thermographic) inspections in Ajax

An infrared camera shows missing insulation, air leaks and damp spots without opening a wall, but only when it's at least 10°C colder outside than inside. Ajax's long heating season gives you months of good scanning weather.

Hands holding an infrared camera aimed at a ceiling corner beside a frosty window; the screen shows a cold streak

Cost

Usually included; confirm

Best conditions

≥10°C inside/outside difference

Too little difference and leaks barely show

Winter design temperature

−19.8°C

The cold day heating is sized for

Houses built before 1961

6%

Older houses usually leak more and have less insulation

How Ajax is built

Ajax's houses by when they were built Ten house shapes, one for each tenth of Ajax's 35,260 houses. Before 1961: 6%, 1961–1990: 36%, 1991–2000: 15%, 2001 or later: 44%. Older houses glow hotter.
  • Before 1961 6%
  • 1961–1990 36%
  • 1991–2000 15%
  • 2001 or later 44%
Each house stands for one in ten of Ajax's 35,260 houses (single-detached, semi-detached, row and duplex), drawn by when it was built. The glow shows the usual pattern: older houses tend to be leakier and less insulated. More snow in the drawing means more heating degree-days: a longer, colder heating season. Sources: Statistics Canada 2021 Census (table 98-10-0233-01), NRCan HOT2000 climate data.

When to book in Ajax

Ajax gets about 3,863 heating degree-days a year, a measure of how much heating its climate needs, and its winter design temperature, the cold day heating systems are sized for, is −19.8°C. Those figures come from the climate data for Toronto Buttonville, the closest comparable location in that data set (27 km away) in HOT2000, the home-energy software Natural Resources Canada (NRCan) gives energy advisors. That gives Ajax a long window, roughly late fall to early spring, when the inside-outside difference comfortably exceeds the 10°C an infrared scan needs.

A 1950s brick bungalow on a snowy suburban street at dusk, lamplight in the front window
The same bungalow as an infrared camera sees it: heat glowing around the door, window frames, eaves and the rim joist above the foundation
Illustration: the same house in visible light and in infrared. A winter scan shows where heat escapes: door and window edges, the eaves, and the rim joist above the foundation.

What the camera finds in Ajax houses

Of Ajax's 35,260 houses (single-detached, semi-detached, row houses and duplexes), 6% were built before 1961 and 42% before 1991, according to the 2021 Census. Older houses are where the camera earns its keep: empty or settled wall cavities, gaps at the top of walls, and cold corners where framing bridges the insulation. Run it with the blower door test depressurizing the house and every leak shows up as a cold streak.

What it costs

Most EnerGuide advisors include an infrared scan with the evaluation, but it isn't required, so confirm when you book. Typical Ontario prices are about $500–$700 for the initial EnerGuide evaluation and $200–$450 for the follow-up, plus HST where it applies. Windfall Ecology Centre charges $500 + HST for the initial evaluation and $250 + HST for the follow-up, Reep Green Solutions charges $540 and $406 with no HST, and City-backed programs in Ottawa and London quote $500–$700 as typical for the first visit. Only assessments from the seven HRSP-approved organizations qualify for the $600 Home Renovation Savings rebate, and none of the seven publishes a price.

Great Lakes–St. Lawrence Southern Ontario and southern Quebec

What this means in Ajax’s climate

Cold winters and hot, humid summers: seal the attic, dry the basement, plan cooling.

Why it matters here: Shows missing insulation and air leaks as cold spots.

Best timing: December to February, early morning or on an overcast day, with at least 10°C between inside and outside.

What else homes in Ajax need →

Sources for this climate guide · checked October 26, 2026

NRCan-licensed service organizations serving Ajax

A service organization is a company that Natural Resources Canada (NRCan) licenses to deliver EnerGuide evaluations; its registered energy advisors do the home visit. Most EnerGuide advisors bring an infrared camera, but it isn't a required part of the evaluation, so confirm when you book. The scan is most useful with the blower door running.

Only assessments from the seven HRSP-approved organizations qualify for the $600 Home Renovation Savings rebate and its assessment-path upgrade rebates; each listing below says whether it's one of them.

Source: NRCan list of licensed service organizations, checked September 28, 2026. Call to confirm your street is covered and ask about wait times.

Programs and local help in Ajax

Thermal imaging inspection in Ajax: common questions

When is the best time for a thermal imaging inspection in Ajax?

Late fall through early spring, when it is at least 10°C colder outside than inside. Cold, overcast days with no direct sun on the walls give the clearest images.

Can a thermal camera see through walls?

No. It reads surface temperatures. Missing insulation or an air leak shows up because it changes the temperature of the wall or ceiling surface.

Who does thermal imaging in Ajax?

Most of the 27 NRCan-licensed organizations serving Ajax bring an infrared camera to an EnerGuide evaluation; confirm when you book.

Is thermal imaging the same as a thermographic inspection?

Yes. Thermography, thermal imaging and infrared scanning all mean reading surface temperatures with an infrared camera.

Thermal imaging inspection near Ajax

Get matched with a registered advisor in Ajax

Tell us your postal code and what you’re planning. We’ll connect you with one licensed service organization serving your area. No spam, no shared lead lists.