British Columbia · Energy · checked September 28, 2026

Thermal imaging (thermographic) inspections in Burnaby

An infrared camera shows missing insulation, air leaks and damp spots without opening a wall, but only when it's at least 10°C colder outside than inside. Burnaby's mild winters make timing the scan the main thing to plan.

Get matched in Burnaby → How an infrared scan works
Hands holding an infrared camera aimed at a ceiling corner beside a frosty window; the screen shows a cold streak

Cost

Usually included; confirm

Best conditions

≥10°C inside/outside difference

Too little difference and leaks barely show

Winter design temperature

−4.4°C

The cold day heating is sized for

Houses built before 1961

18%

Older houses usually leak more and have less insulation

How Burnaby is built

Burnaby's houses by when they were built Ten house shapes, one for each tenth of Burnaby's 47,540 houses. Before 1961: 18%, 1961–1990: 40%, 1991–2000: 15%, 2001 or later: 27%. Older houses glow hotter.
  • Before 1961 18%
  • 1961–1990 40%
  • 1991–2000 15%
  • 2001 or later 27%
Each house stands for one in ten of Burnaby's 47,540 houses (single-detached, semi-detached, row and duplex), drawn by when it was built. The glow shows the usual pattern: older houses tend to be leakier and less insulated. Rain marks the mild, wet winters: here moisture, not deep cold, is the main winter risk. Sources: Statistics Canada 2021 Census (table 98-10-0233-01), NRCan HOT2000 climate data.

When to book in Burnaby

Burnaby gets about 2,768 heating degree-days a year, a measure of how much heating its climate needs, and its winter design temperature, the cold day heating systems are sized for, is −4.4°C. Those figures come from the climate data for Vancouver International in HOT2000, the home-energy software Natural Resources Canada (NRCan) gives energy advisors. With winters that mild, a 10°C difference isn't guaranteed every day, so book the scan for a cold morning or evening, and ask the advisor to reschedule if the forecast is too warm.

A 1950s brick bungalow on a snowy suburban street at dusk, lamplight in the front window
The same bungalow as an infrared camera sees it: heat glowing around the door, window frames, eaves and the rim joist above the foundation
Illustration: the same house in visible light and in infrared. A winter scan shows where heat escapes: door and window edges, the eaves, and the rim joist above the foundation.

What the camera finds in Burnaby houses

Of Burnaby's 47,540 houses (single-detached, semi-detached, row houses and duplexes), 18% were built before 1961 and 58% before 1991, according to the 2021 Census. Older houses are where the camera earns its keep: empty or settled wall cavities, gaps at the top of walls, and cold corners where framing bridges the insulation. Run it with the blower door test depressurizing the house and every leak shows up as a cold streak.

What it costs

Most EnerGuide advisors include an infrared scan with the evaluation, but it isn't required, so confirm when you book. There's no provincial price list; the City of Nanaimo quotes $400–$500 as typical for an existing home. Several B.C. municipalities subsidize evaluations for their residents (see local programs below).

Coastal BC Lower Mainland and Vancouver Island

What this means in Burnaby’s climate

Mild, wet winters and summer heat waves: fix moisture first, then cooling and heat pumps.

Why it matters here: Shows missing insulation and air leaks as temperature differences on walls and ceilings.

Best timing: December to February, early morning or evening, with at least 10°C between inside and outside, little sun and low wind.

  • Seal air leaks, then top up the attic. NRCan calls air sealing the most important retrofit. Pair it with attic insulation: today's new-home minimum here is about R-39, a useful target for older attics. Ask: Ask for a blower door test before and after sealing, so you can see the drop in ACH50.

What else homes in Burnaby need →

Sources for this climate guide · checked October 26, 2026

NRCan-licensed service organizations serving Burnaby

A service organization is a company that Natural Resources Canada (NRCan) licenses to deliver EnerGuide evaluations; its registered energy advisors do the home visit. Most EnerGuide advisors bring an infrared camera, but it isn't a required part of the evaluation, so confirm when you book. The scan is most useful with the blower door running.

Source: NRCan list of licensed service organizations, checked September 28, 2026. Call to confirm your street is covered and ask about wait times.

Programs and local help in Burnaby

Provincial · needs an evaluation BC Home Energy Improvement Bonus $20 for every percentage-point your home improves — $750 minimum, $2,000 maximum — or $300 for any two upgrades Open

Thermal imaging inspection in Burnaby: common questions

When is the best time for a thermal imaging inspection in Burnaby?

Pick a cold morning or evening in winter; the camera needs at least a 10°C difference between inside and outside, which isn't guaranteed every winter day in Burnaby.

Can a thermal camera see through walls?

No. It reads surface temperatures. Missing insulation or an air leak shows up because it changes the temperature of the wall or ceiling surface.

Who does thermal imaging in Burnaby?

Most of the 29 NRCan-licensed organizations serving Burnaby bring an infrared camera to an EnerGuide evaluation; confirm when you book.

Is thermal imaging the same as a thermographic inspection?

Yes. Thermography, thermal imaging and infrared scanning all mean reading surface temperatures with an infrared camera.

Thermal imaging inspection near Burnaby

Thermal imaging inspection in Coquitlam8 kmThermal imaging inspection in Vancouver10 kmThermal imaging inspection in Richmond14 kmThermal imaging inspection in Delta16 kmThermal imaging inspection in Surrey17 km All 70 cities →

Sources

Checked September 28, 2026. Census figures are for the municipality (British Columbia); climate data is NRCan's HOT2000 station Vancouver International (16 km away).

Get matched with a registered advisor in Burnaby

Tell us your postal code and what you’re planning. We’ll connect you with one licensed service organization serving your area. No spam, no shared lead lists.

By submitting you agree we may share your request with one registered service organization serving your area. Participating advisors pay us a referral fee — you pay nothing, and it never affects the directory. See our privacy note.